Install Internal Hard Disk Drives

Applicability

• ECA4.x - MX and VW series

Description

• The MX and VW series supports internal Hard Disk Drive.

• Follow the installation steps in this guide carefully

---

Install Internal HDD1 and HDD2

1. Open and remove the ECA chassis cover.

1. Remove the six screws that secure the internal HDD cage.

1. Remove the internal HDD cage.

1. Install HDD into the cage. For each HDD, there are 3 screws on each side to fasten.

HDD Screw

1. Remount the HDD cage, with the HDDs installed, into the chassis. Make sure the orientation is correct as shown in the images below:

1. Connect the SATA and Power connectors to HDD1 and HDD2 accordingly. The SATA cables are number labelled.

1. Fasten the screws for the HDD cage. Then, close chassis cover.

Install Internal HDD3

1. Open Chassis cover. Then, remove the HDD mounting bracket from the chassis.

Top view

Bottom of chassis

1. Mount the HDD onto the mounting plate.

There are two screws on each side.

1. Install the mounting plate (with HDD installed) into the Chassis.

1. Connect the SATA and Power connectors to HDD3.

1. Fasten the 8 screws removed in first step.

2. Close chassis cover.

Overall view when all 3 HDDs are installed